2018 Kverneland 6716 Series SC-14

2018 Kverneland 6716 Series SC-14

Kverneland 6716 - 6720 - The new industry leaders in bale density. This is achieved through Intelligent Density 3D, a system which allows you to choose the bale density best suited to your crop conditions. You can even bale up to 2 metres in diameter. The performance and versatility of the 6700 series improves efficiency and lowers your costs.

Features may include:

• Intelligent Density 3D with new easy setting of bale density - pre-selectable from the tractor cab.

• PowerBind with direct net injection for fast and highly reliable netting.

• Easy and simple loading of net roll.

• ISOBUS control

• 2.2 m pick-up with small diameter.

• PowerFeed rotor intake for impressive intake capacity.

• SuperCut-14 and 25 knife rotors for efficient cutting and tight bales.

• DropFloor for easy unblocking.

• 3 different core densities, pre-selectable from the tractor cab

• One of the fastest net wrap actions available. This means minimum downtime and maximum time baling.

• The net is fed directly into the bale chamber by an injection arm in a flat movement angle to keep the net tight at all times.

• Accurate and extremely reliable net injection.

• No interference from external factors such as wind and crop.

• When the bale is 90% complete the injection arm moves forward, ready for the net injection. No time is spent picking up the net. In fact

• Very low loading height, for maximum convenience and time saving. To replace the empty roll just swing out the shaft and replace it with a new roll

• The PowerBind net wrap system allows the net to extend past the edge of the bale

• Setting and selection of correct bale density is vital in order to the get right quality of the bale. Especially when the baler is utilized through the full season in different crops like straw, hay and silage it is important to adjust the bale density to specific type of material.

• Intelligent Density 3D with 3 pre-selected bale density settings making it very easy to choose the correct bale density in different crops.

• It is however still possible to customize the bale density in 3 separate zones each with a choice of diameter and pressure to match specific request.

• With the new Intelligent Density 3D application three pre-configured bale densities are available from the menu of the control box, each of them tailored for straw, hay or silage. This makes the change-over from different crop material much easier limiting the risk of mistakes.

• Baling dry straw and want the heaviest bales possible? Maximum pressure is set in every zone.

• Baling hay? Soft centre core to let the bale breath is set, with gradually increasing pressure towards the outer layer.

• Baling wet silage? Pressure is reduced in the centre and mid zones

• 2.2m pick-up with small diameter pick-up reel for fast and efficient throughput.

• Pick-up with 5 rows of tines

• Twin cam tracks.

• Tine bars with two central supports.

• Small diameter pick-up design.

• Roller crop press is standard.

• Narrow transport width no need to remove the pick-up wheels for transport

• Kverneland Drop Floor enables the operator to clear blockages easily from the tractor cab without any crop loss.